ATMEGA8 Project Kit supports 28-pin DIP AVR microcontrollers such as ATMEGA8, and ATMEGA328.
Features :
Project Kit supports ATMEGA8, ATMEGA48, ATMEGA88, ATMEGA168, and ATMEGA328.
Project Kit can be powered from any general DC adaptor 8-20V thanks to an on-board 5V regulator.
On-board reverse polarity protection.
All Microcontroller pins are exposed to screw clamp terminals for easy access.
Large size work area 144 horizontal lines X 5 points, 36 X 3 vertical 5V lines, 36 X 3 vertical GND lines, 36 lines X 2 points (Blue pill pins in addition to power rails GND, 5V, VIN).
Project Kit includes a green LED for power indication.
6-Pin ICSP header socket for connecting an external programmer (no need for removing chip).
Project Kit provides a 16MHz crystal oscillator.
Project Kit contains a Reset switch.
Four 7mm M-F spacers are added to keep the board out of any wires and components erroneously located under the board.
This USB to RS485 converter is based on CH340 USB to serial IC. It provides a virtual serial port over a USB 2.0 port. Serial signals are provided in RS485 level to screw clamp terminal. Once you have installed the drivers, the module will appear as a normal serial COM port on your computer, making it compatible with most terminal programs and development environments.
Features:
Provides virtual serial port over USB2.0 port.
MAX487 transceiver.
Supports Win 7, 8, 10, and 11 32/64-bit.
B-type socket full-speed 2.0 USB interface.
USB-powered (5V).
Half-duplex serial mode.
RS485 data rate up to 250 Kbps.
Serial baud rate up to 2 Mbps.
Up to 128 nodes on bus.
TVS protection ±30 KV ESD.
PTC (JZ) for overcurrent fault protection.
120 Ohm terminal resistor included.
Red LED indicator for Rx and Tx signals.
Green LED for power status.
One (Ø 3.5mm) mounting hole for easy installation.
Compact USB programmer for AVR microcontrollers with voltage selection, speed jumper, and clear status indication.
Features :
Supported Devices: Compatible with most AVR 8-bit microcontrollers such as ATmega8, ATmega16, ATmega32, ATmega328, ATmega128, ATtiny series, and AT90 series.
USB Type-A Connector: Direct connection to PC without extra cables.
Supports low-clock speed programming via jumper setting.
Target Power Selection: 3-pin header with jumper to supply the target device with 5V, 3.3V, or completely disconnect power.
Flexible Connectivity: Two options for connecting to the target device:
6-pin XH cable header.
10-pin IDC socket.
10-Pin IDC cable is included.
Green LED: Indicates normal operation.
Red LED: Indicates programming in progress (busy).
Firmware Upgradable: Dedicated PRG header for easy firmware updates.
Wide Compatibility: Supports various AVR microcontrollers and works seamlessly with tools like AVRDUDE.
Compact PCB Design: Small form factor for convenient use in different projects.
Dimensions(L X W X H): 75X20X12 mm (including connectors)
